Isotech TTI 7 PLUS - Appendix I: Command Summary; Programming Language; Measurement Configuration Commands; Triggering Commands

Page 41 of 44
TTI-7 Iss.02 – 06/11
APPENDIX I: COMMAND SUMMARY
Programming Language
All interfaces use the same commands.
For the RS-232 interface these commands are sent as part of a serial string.
For the IEEE-488 interface these commands are sent as a Multi-wire Interface Message (with ATN=High).
Measurement Configuration Commands
CONFigure
:CHANnel < channel>
:TEMPerature:TC <type>,<rj mode>,<ext rj standard>
:TEMPerature:RTD <type>,<standard>,<con>,<current mode>,<root 2>
CONFigure?
MEASure
:TEMPerature:TC? <type>,<rj mode>,<ext rj standard>
:TEMPerature:RTD? <type>,<standard>,<con>,<current mode>,<root 2>
:CHANnel? <channel>
SENSe
:TEMPerature:UNIT <parameter>
:TEMPerature:UNIT?
:TEMPerature:RESolution <resolution>
:TEMPerature:RESolution?
Triggering Commands
INITiate
*TRG
FETCh[:< function >]?
READ?
ABORT
TRIGger
:MODE < SINGle/INFinite >
:MODE?
:COUNt <n>
:COUNt <slx>, <n>
:COUNt?
:COUNt? <slx>
:DELay <hh:mm:ss>
:DELay <slx>, <hh:mm:ss>
:DELay?
:DELay? <slx>
:SAMPle:COUNt?
:SAMPle:COUNt? <slx>
:SAMPle:DELay <slx>, <hh:mm:ss>
:SAMPle:DELay? <slx>