EasyManua.ls Logo

Isotronic 70048 - Installation and Maintenance

Isotronic 70048
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Consigne sur la protection de l´environnement
Ce produit ne doit pas être jeté dans vos ordures ménagères lorsqu´il parvient en
fin vie, mais doit être déposé dans un centre de collecte pour le recyclage
d´appareils électriques et électroniques. Le symbole indiqué sur le produit, dans
le mode d´emploi ou sur l´emballage le signale. Les matériaux sont réutilisables
selon leurs caractéristiques. Grâce au recyclage, à la réutilisation matérielle ou
toute autre forme de recyclage, vous contribuez considérablement à la protection
de notre environnement. Veuillez vous informer auprès de votre municipalité pour
connaître le centre de collecte compétent.
Instructions for Use
Vole Repeller - This appliance not only repels rodents,
ants and even snakes!
Article No. 70048
Dear Client,
Congratulations for choosing one of our quality products. Please follow these
instructions carefully and keep them with you.
Repel rodents through vibrations – no chemicals, no ground pollution!
1. Product description
This vole repeller device is one of the new generation of repellers! It generates
quartz vibrations in approx. 50 sec intervals within a frequency range of 400 –
1.000 Hz ± 50 Hz. Outdoor test showed that these specially generated vibrations
have an optimum effective area of approx. 1.250 m², depending on condition of
soil. Since rodents cannot stand these quartz vibrations they move to other areas
within a few days. Other useful animals are not harmed. The Vole Repeller can
be used in the garden, in the field or in other outdoor areas with unwanted
rodents. This appliance not only repels rodents, ants and even snakes!
2. Installation and maintenance
Dig the device into the ground up to ¾ of the Vole Repeller. Your Vole Repeller
is now ready for operation. Check the function of the device regularly. In case it
does not work normally any more, a replacement of the batteries might be
necessary (see point 3).
Installation suggestion (see drawing):
Place the repeller in such a position that animals will have the possibility to flee
from your land.
After about 5-6 weeks the device/s should be moved approximately 4-5 metres in
the direction of the escape route.