Page 9 www.123filter.com | (678) 261-7611 | support@123filter.com
Disclaimers: This Limited Warranty applies only if the system is installed, used, and maintained in
compliance with all instructions and requirements enclosed with the system. This warranty will be
void for failure to observe the following conditions:
1. The system is to be used with potable water supply only.
2. Feed water pressure to the unit is no less than 45 psi (30 psi for systems with built-in booster
pump) and no greater than 70 psi.
3. The system is to be used on water supplies with chlorine concentrations of 1.0 mg/L (ppm) or
less.
4. Feed water temperature to the unit must be no less than 40°F and no more than 100°F.
5. Total dissolved solids (TDS) in feed water must be less than 750 mg/L (ppm).
6. Feed water must have a pH between 4 and 8.
7. Turbidity must be less than 1.0 NTU.
8. SDI must be less than 5.
9. Feed water must be completely free of iron, manganese or hydrogen sulfide.
While the testing was performed under standard laboratory conditions, actual performance may
vary. The Manufacturer does not know the characteristics of your water supply. The quality of
water supplies may vary seasonably or over a period of time. Your water usage may vary as well.
Water characteristics can also change if the drinking water appliance is moved to a new location.
The Manufacturer assumes no liability for the determination of the proper equipment necessary to
meet your requirements, and we do not authorize others to assume such obligation on our behalf.
This Limited Warranty does not cover any Manufacturer-supplied items that are defective as a
result of the use of improper parts, equipment or materials. This warranty does not cover alterations
or modifications of the unit or failure of a unit caused by such alterations and modifications.
This Limited Warranty does not cover malfunctions of the unit due to tampering, misuse, alteration,
lack of regular maintenance, misapplication, fouling due to hydrogen sulfide, manganese or iron,
scaling from excessive hardness, turbidity greater than 1.0 NTU, Silt Density Index (SDI) greater
than 5.0 SDI, or excessive membrane hydrolysis due to chlorine levels in excess of 1.0 mg/L (ppm).
In addition, damage to the unit due to fire, accident, negligence, act of God, or events beyond the
control of the Manufacturer are not covered by this warranty.
Incidental and Consequential Damages Limitation: The Manufacturer will not be responsible for
any incidental or consequential damages as a result of the failure of this unit to comply with
express or implied warranties or any defect in the unit, including but not limited to, lost time,
inconvenience, damage to personal property, loss of revenue, commercial losses, postage, travel,
telephone expenditures, or other losses of this nature. In case some states do not allow the exclusion
or limitation of incidental or consequential damages, you may choose to return the system. If you
choose to keep it, you insist this exclusion STILL apply to you.
Owner’s Warranty Responsibilities: As a condition of this Limited Warranty, the owner must
ensure that periodic maintenance of the system is performed as described in the literature enclosed
with the system. Neglect, improper maintenance, abuse, modification, or alteration of the unit will
invalidate this Warranty. Should your unit develop a defect or otherwise fail to perform in
accordance with this warranty, you should contact the retailer from whom the product was
originally purchased.
Implied Warranties: The implied at-law warranties of merchantability and fitness for a particular
purpose shall terminate on the date one year after the date of purchase.
NOTE: IN CASE SOME STATES DO NOT ALLOW LIMITATIONS ON HOW LONG AN
IMPLIED WARRANTY LASTS, YOU MAY CHOOSE TO RETURN THE SYSTEM. IF
YOU CHOOSE TO KEEP IT, YOU AGREE THAT THE ABOVE LIMITATIONS STILL
APPLY TO YOU.
To Next Page
Loading...
Need help?
General
