Installation
1) Preparation
A. It is strongly recommended to watch the video "iSpring RO500 Tankless RO Reverse
Osmosis 500GPD Water Filtration System DIY Installation" on Youtube.com prior to
installation.
B. Choose a suitable location for the system. Again, it cannot be mounted and must be placed
on a flat surface and make sure this system is to be installed on INDOOR cold-water supply
ONLY.
C. Check the packing list to confirm all accessories are included in the package. Contact
iSpring customer service if any components are missing.
D. Required tools:
2) Feed Water Adapter Installation
• Turn off the cold-water supply valve and unscrew the kitchen faucet connector pipe.
• Install the feed water adapter on the cold-water supply valve and tighten with a spanner
wrench: (make sure the O-ring is seated inside the adapter).
• Re-install the cold-water hose on the feed water adapter, then tighten with a spanner
wrench (make sure the O-ring is seated inside the hose cap).
Page 7 www.123filter.com | (678) 261-7611 | support@123filter.com
To Next Page
Loading...
Need help?
General