www.123filter.com | +1 (678) 261-7611 | support@123filter.com Page 3
User Information & Guidelines
The user must adhere to the specifications described in this Product Installation and Operation
Manual (hereinafter referred to as the "instruction manual"). iSpring is not responsible for damage,
loss, or injury resulting from neglect, improper maintenance, or unauthorized unit modification.
● The unit should be placed only on flat surfaces. Do not mount it on a wall.
● This product is designed for residential use. Contact iSpring customer service to inquire about
using it in non-residential settings.
● The operating temperature range is 40°F - 100°F. If the water temperature or ambient temperature
falls below 40°F, immediately shut off the inline water supply, turn off the inline water adapter,
and drain the remaining water from the system. Failure of the water supply line or water purifier
may result in malfunction, damage, and possible injury to the enclosure or water supply line.
● If leaking occurs, shut off the inline water supply and contact iSpring customer service.
● Use only authorized iSpring parts. Using unauthorized or aftermarket components will void the
product warranty.
● It is recommended that users check external fittings and connections regularly to ensure all
components are secure.
● Unauthorized modification and disassembly are strictly prohibited and will void the warranty.
● Product installation and use must strictly comply with the requirements of this manual. Do not
perform any operation on the product without reading and understanding the contents of this
manual.
● Activation of this product indicates that the owner has carefully read, understood, and accepted
the contents of this manual, including the safety notices and instructions.
Product Operation & Specifications
Though testing was performed under standard laboratory conditions, the actual performance of the
system may vary based on local water conditions and quality.
● This system is designed to be used on a cold supply ONLY and kept away from freezing
environments.
● All inlet and outlet pipes are recommended to use water pipes and fittings that meet the
appropriate standards of domestic drinking water. The connection of water pipes should comply
with national or industry standards, and the pipe connections should comply with relevant federal
installation regulations.
● If the water inlet pressure is higher than 100 psi, a pressure-reducing valve must be installed at
the water inlet pipe of the water purifier. If the water inlet pressure is lower than 35 psi, a booster
pump must be installed at the water inlet pipe of the water purifier to ensure the working pressure
meets technical requirements.
● Heat preservation measures should be executed if the inlet water temperature is higher or lower
than the requirement.
Note
◼ Failure to operate the product per this manual may result in product damage, water leakage, seepage,
injury, or other losses.
To Next Page
Loading...
Need help?
General
