Page 23
www.123filter.com | (678) 261-7611 | support@123filter.com
Water system pressure is too low or
too high
Install pressure stabilization
equipment.
Control valve failure
Filter material
performance reduce
The back wash flow rate is too large
or too small
Verify the water pressure is 20
~ 125 psi.
Regeneration start time
is incorrect
The control valve is inaccurate due
to power failure
Adjust the current time of the
control valve.
The regeneration start time is set
incorrectly
Adjust regeneration start time.
For operating procedures, refer
to the current time in the
Need help with troubleshooting? If you have any questions or find there are missing parts or
damage, please call 1-678-261-7611 or visit www.ispringfilter.com
When calling, please be prepared to provide the model of your product.
To Next Page
Loading...
Need help?
General
