Istore 180L - Page 32

iStore - Installation Manual - Aug 2023
32
Appendix
Use of the Overheating Protector
The overheating protector is used to turn the power o, preventing the water from being heated too
high. To return the unit to its normal operational status it will have to be reset manually by qualied
personnel.
The thermal cut-out is pre-installed in the system, no on-site installation or commissioning is
required. The recommended factory setting is 60º Celsius to prevent the thermal cut-out from
operating. The thermal cut-out operation temperature is 85º Celsius.
Loosen the screws and open the cover Push the red button
Earthing