I I I I I I I I I I I I I I I I I I I I I I I I I I I I I I I I I I I I I II I I I I I I I II II II Ill1 l l l l l l l
ENGINE ASSEMBLY *iI 4-29
t
Connecting Rod Bushing Installation
cl
*c
Use the connecting rod bushing installer to install the
connecting rod bushing.
lal
bl
Connecting Rod Bushing Installer: 9-8523-1369-O
(J-29765)
lrrl
Note:
The connecting rod bushing oil port must be
aligned
with the connecting rod oil port.
3, Use a piston pin hole grinder @ fitted with
a reamer
@ or an adjustable pilot reamer to ream the
piston
pin hole.
Connecting Rod Bushing
Inside Diameter
mm (in)
Standard
35.017-35.025
i
(1.37861.3789)
El
e
Connecting Rod Bearing Inspection
1. Fit the connecting rod bearing lower half
into the
III
connecting rod bearing cap.
*c
2. Check the connecting rod bearing lower half tension.
If the tension is insufficient, the bearing must be
v
replaced.
3. Tighten the connecting rod and the bearing
cap
to
the specified torque.
kgom(lb.ft)
Connecting Rod and Bearing
4
Cap Bolt Tightening Torque
(28.9)
60’090’
.
@I
4. Use an inside dial indicator to measure the connect-
:
ing rod inside diameter.
mm
(in)
Connecting Rod Bearing
e Nominal Diameter
64(2.520)
To Next Page
Loading...
