ENGINE ASSEMBLY Ill 543
2) Install the oil pump with the coupling.
3) Tighten the oil pump
bolts
to the specified
torque.
kg*m (Ib.ft)
I
Oil Pump Bolt Torque 4.3-6.3 (31.1-45.6)
I
13. Flywheel Housing
1) Apply a liquid gasket to the shaded area of the
illustration.
2) Install the flywheel housing.
Tighten the flywheel housing bolts to the speci-
fied torque.
kgem (Ib.ft)
Flywheel Housing Outer Bolt
15.0-17.0 (108-123)
Bait Torque
Inner Bolt
2.1-3.1 (15.2-22.4)
14. Oil Pan
1) Apply liquid gasket to the area indicated by the
arrows in
the
illustration.
2) Install the oil pan gasket
3) install the oil pan.
Tighten the oil
pan bolts to the specified torque.
kg*m (I b.ft)
I-
Oil Pan Bolt Torque
I
2.1-3.1 (15.2-22.4)
I
15. Oil Cooler
1) Apply liquid gasket to the oil cooler gasket.
2) Install the oil cooler gasket to the oil cooler body
case.
3) Install the oil cooler.
Tighten the oil cooler bolts to the specified
torque.
Start from the middle and work out to either
side.
Refer to the illustration
kgom (I b.ft)
Oil Cooler Torque
4B
1 S-2.6 (11.6-18.8)
6B
1.402.4(10.1-17.4)
To Next Page
Loading...
