4-112
CONTROLS AND INSTRUMENTS
4. When shifting up from "4" (4th gear) to
"5" (5th gear), check that the indicator
light remains off and then place the
gearshift lever into the "1" (1st gear)
position. Move the gearshift lever from
"5" (5th gear) to "8" (8th gear) with the
selector switch left in the high range
position.
When shifting down from "5" (5th
gear) to "4" (4th gear), check that the
low range indicator light is on and
then place the gearshift lever into the
"4" (4th gear) position.
CAUTION
Fully depress the clutch pedal before operating the gearshift lever.
Do not change to the low range at 30 km/h (19 MPH) or higher speeds. Doing
so may cause a failure in the transmission.
Operate the selector switch immediately before the gear change operation.
If the selector switch is operated too early, gear shifting does not take place
correctly and the transmission may be damaged.
•
•
•
NOTE
If low-high range switching becomes impossible
If low-to-high range switching is impossible, you can still drive the vehicle.
Have your vehicle inspected at the nearest Isuzu Dealer promptly.
If high-to-low range switching becomes impossible, you cannot drive the
vehicle. Immediately stop your vehicle at a safe place and contact the nearest
Isuzu Dealer.
If the vehicle speed exceeds approximately 17 km/h (11 MPH) while the low
range is being used, shifting from "3" (3rd gear) or "4" (4th gear) to "1" (1st
gear), "2" (2nd gear), "C1" (crawler 1 gear) or "R1" (reverse 1 gear) is prevented
from taking place. (The gate interlock mechanism works.)
If the vehicle speed exceeds approx. 30 km/h (19 MPH) while the high range is
being used, switching from the high range to the low range is prevented from
taking place. (The range interlock mechanism works.)
•
-
-
•
•
4608498sec04CONTROLSANDINSTR4-1124-1124608498sec04CONTROLSANDINSTR4-1124-112 2015/11/0213:59:502015/11/0213:59:50
To Next Page
Loading...
