4-193
CONTROLS AND INSTRUMENTS
PTO is a device that is used to provide engine power to special equipment directly from
the engine or through the transmission. This manual describes operation of the PTO,
but for operation of any special equipment other than the PTO switch, please consult
the separate Instruction Manual for the Special Equipment.
Power Take-Off (PTO)
V
When Operating the PTO
CAUTION
Before operating the PTO, make sure that there are no persons or objects
around and above the vehicle.
Operate the PTO in a level surface.
When operating the PTO and special equipment, be sure to place the gearshift
lever into the "N" position, firmly pull the parking brake lever and keep the brake
pedal fully depressed with your right foot.
Do not operate the PTO or special equipment while driving.
For the operation method of special equipment, consult the separate Instruction
Manual for Special Equipment.
Do not shift gears when the PTO is engaged.
•
•
•
•
•
•
ADVICE
The PTO of the Smoother model cannot be engaged when the engine speed
is high to prevent a failure of the system. PTO cannot be engaged during fast
idle control that takes place immediately after the start of a cold engine or when
the engine speed is increased using the idling control knob. Wait until engine
warm up completes or return the idling control knob to the lowest setting before
operating the PTO switch.
•
NOTE
[Fast idle control]
A supplementary function to warm up the engine by automatically increasing the
idling speed while the engine is cold.
•
4608498sec04CONTROLSANDINSTR4-1934-1934608498sec04CONTROLSANDINSTR4-1934-193 2015/11/0214:00:112015/11/0214:00:11
To Next Page
Loading...
