7-13
SERVICE AND MAINTENANCE
2. Remove the tilt support lock pin and
place it in the holder.
3. Pulling the tilt support while pressing
the lock with your right hand will
cause the tilt support to bend,
lowering the cab. After the tilt support
has bent, grasp the grip (4) with both
hands and lower the cab completely.
CAUTION
Do not operate the tilt lock lever
while the cab is being lowered.
When a load is attached to the
outside or inside of the cab, or the
cab is loaded, be advised that the
cab will lower faster.
•
•
Lock pin
Holder
Lowering the Cab
1. Support the cab while gripping the
grip (4) with your left hand.
WARNING
After lowering the cab, make sure the cab is securely locked.
When the starter switch is turned to the "ON" position with the lock being
incompletely engaged, the cab tilt warning light (if equipped) will come on or a
warning message (model with MID) will be displayed.
•
•
4608498sec07SERVICEANDMAINTE7-137-134608498sec07SERVICEANDMAINTE7-137-13 2015/11/049:59:282015/11/049:59:28
To Next Page
