7-23
SERVICE AND MAINTENANCE
6. When the cab is fully lowered and the
motor sound stops, release the switch
(4) and raise the handle (1) until the
lever (2) catches.
7. When the handle (1) is securely
locked, the warning buzzer will stop.
Place the starter switch in the "ON"
position and make sure that the cab
tilt warning light (if equipped) does not
come on and that a warning message
(model with MID) is not displayed.
Cab Tilt Warning Light
V
→ Refer to page 4-59
1
2
CAUTION
After the cab is lowered to the
original position, be sure to maintain
the lever (3) in the "lower (running)"
position and lock the cab by using
the cab lock system.
The tilt cylinder will operate until the
sound of the motor stops, even if the
cab is fully lowered. Releasing the
switch (4) before the sound of the
motor stops could damage or harm
the tilt cylinder or the vehicle body.
•
•
4608498sec07SERVICEANDMAINTE7-237-234608498sec07SERVICEANDMAINTE7-237-23 2015/11/049:59:322015/11/049:59:32
To Next Page
