v.081118
3
ENGLISH
15. USE EYE PROTECTION. Use a full-face mask if the work you’re doing
produces metal lings, dust or wood chips. Goggles are acceptable in other
situations. Wear a clean dust mask if the work involves creating a lot of ne or
coarse dust.
16. SECURE WORK. Use clamps or a vise to hold the work. It’s safer than using
your hands and it frees both hands to operate the tool.
17. DON’T OVERREACH. Keep proper footing and balance at all times. Do not
reach over or across machines that are running.
18. MAINTAIN TOOLS WITH CARE. Keep tools sharp and clean for better and
safer performance. Follow instructions for lubricating and safe performance.
Follow instructions for lubricating and changing accessories. Keep handles dry,
clean and free from oil and grease.
19. AVOID UNINTENTIONAL STARTING. Be sure the switch is in the OFF
position before plugging in.
20. ALWAYS CHECK AND MAKE SURE TO REMOVE ANY ADJUSTING KEYS
OR WRENCHES before turning the tool on. Left attached, these parts can y
off a rotating part and result in personal injury.
21. DO NOT USE THE TOOL IF IT CANNOT BE SWITCHED ON OR OFF. Have
your tool repaired before using it.
22. DISCONNNECT THE PLUG FROM POWER BEFORE MAKING ANY
ADJUSTMENTS. Changing attachments or accessories can be dangerous if
the tool could accidentally start.
23. STAY ALERT. Watch what you are doing & use common sense. Don’t operate
any tool when you are tired.
24. CHECK FOR DAMAGED PARTS. Before using this tool, any part that is
damaged should be carefully checked to determine that it will operate properly
and perform its intended function. Check for alignment of moving parts, binding
of moving parts, breakage of parts, mountings, and other conditions that may
affect its operation. Inspect screws and tighten any ones that are loose. Any
part that is damaged should be properly repaired or replaced by an authorized
service center unless otherwise indicated elsewhere in the instruction manual.
Have defective switches replaced by an authorized service center. Don’t use
the tool if switch does not turn it on and off properly.
25. REPLACEMENT PARTS. When servicing, use only identical replacement
parts.
26. SERVICE AND REPAIRS should be made by qualied repair technicians at an
authorized repair center. Improperly repaired tools could cause serious shock
or injury
WOOD ONLY. This tool is designed for woodcutting only.
DAMAGED OR WARPED SAW BLADES should not be used. They are out
of balance and could cause further damage to the saw and possible personal
injury.
USE ONLY WITH GUARD IN PLACE. The guard protects you, the operator,
from cutting debris as well as from broken pieces of the blade if it breaks in
use.
REPLACE THE TABLE INSERT WHEN WORN. Excessive tear-out increases
the likelihood of injury from ying debris. When setting the saw at a new
angle, check that due to some mis-alignment, the blade does not cut into the
table insert, rear fence, or another part of your saw.
ALWAYS USE THE BLADE WRENCH to tighten the saw blade onto the
arbor.
CONNECT YOUR MITRE SAW TO A DUST COLLECTING DEVICE if
possible. If not, use the dust bag that comes with the tool and empty it
regularly.
USE A SAWBLADE SUITED TO THE CUTTING JOB AND MATERIAL TO
BE CUT.
IMPORTANT SAFETY INSTRUCTIONS
SPECIFIC SAFETY PRECAUTIONS FOR THIS TOOL
To Next Page
Loading...
General