3
2
ENGLISH
FRANÇAIS
FRANÇAIS
ENGLISH
3
2
ENGLISH
FRANÇAIS
FRANÇAIS
ENGLISH
IMPORTANT SAFETY INSTRUCTIONS
13. AVOID UNINTENTIONAL STARTING. Be sure the switch is in the OFF
position before plugging in.
14. ALWAYS CHECK AND MAKE SURE TO REMOVE ANY ADJUSTING KEYS
OR WRENCHES before turning the tool on. Left attached, these parts can y
off a rotating part and result in personal injury.
15. DO NOT USE THE COMPRESSOR IF IT CANNOT BE SWITCHED ON OR
OFF. Have it repaired before using it.
16. DISCONNNECT THE PLUG FROM POWER BEFORE MAKING ANY
ADJUSTMENTS. Changing attachments or accessories can be dangerous
if the tool could accidentally start.
17. MAINTAIN TOOLS WITH CARE. Keep tools clean for better and safer
performance. Follow instructions for lubricating and changing accessories.
Keep dry, clean and free from oil and grease.
18. CHECK FOR DAMAGED PARTS. Make frequent inspections for the correct
function of components and safety mechanism.
19. REPLACEMENT PARTS. When servicing, use only identical replacement parts
and fasteners recommended by us.
20. EMPLOYERS must enforce compliance with the safety warnings and all other
instructions in this manual. Keep it available for use by everyone assigned to
use this equipment.
COMPRESSED AIR CAUTIONS
1. COMPRESSED AIR FROM THIS UNIT MAY CONTAIN CARBON
MONOXIDE. The air produced is neither suitable for breathing nor food
processing without ltering and testing to all applicable legal standards.
2. AIR ONLY: Use this compressor for compressing air only. Do not compress
other gases.
3. BREATHING PROTECTION: Always use a respirator when spraying paint or
chemicals.
5. NEVER USE THIS EQUIPMENT if it is leaking air; has missing or damaged
parts, guards, or shields; or requires repair. Make sure all screws and caps are
securely tightened.
6. DO NOT USE THE AIR HOSE to move the compressor. Release the pressure
in the storage tank before moving.
7. DO NOT ATTEMPT ANY MAINTENANCE OR ADJUSTMENT with the com-
pressor in operation, the power connected, or air under pressure in the system.
1. TANK SAFETY VALVE: This valve prevents damage to the air receiver if a
malfunction in the compressor pump occurs. It is factory pre-set at a limit
specic to your particular model and adjustment. Do not tamper with it. This
will automatically void your warranty.
2. PRESSURE SWITCH: The air pressure switch is factory pre-set for optimum
performance. Do not bypass or remove this switch. Serious damage to
equipment or personal injury could result from too high an air pressure.
3. MOTOR AND COMPRESSOR PUMP: Air compressors get hot during opera-
tion. Do not touch the motor, discharge tubing, or compressor while it is run-
ning.
The compressor turns itself on automatically while the power is connected.
4. AIR TANK: Over-pressurizing the air receiver, piping or tank could cause
it to explode or burst. To protect from over-pressurizing, the compressor is
equipped with a factory preset safety valve. Do not remove, make adjustments
to or substitutions for this valve. Perform a test of the valve from time to time:
pull the ring on the valve to make sure that it operates freely. If the valve does
not operate freely, replace it before further use. Never weld to, drill into, or
change the air receiver in any way.
5. TAMPERING: If any of the components above are found to have been changed
or tampered with, the warranty will be made void. When servicing, we recom-
mend using only identical replacement parts and any replacement parts used
must have the same specication as the original equipment.
SAFETY PRECAUTIONS SPECIFIC TO COMPRESSOR
To Next Page
Loading...
Need help?
General