EasyManua.ls Logo

ITC SPT280 User Manual

ITC SPT280
26 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Page #1 background imageLoading...
Page #1 background image
SAVE THIS MANUAL
You will need this manual for safety instructions, operating procedures,
and warranty. Put it and the original sales invoice in a safe, dry place for
future reference.
CONSERVEZ CE GUIDE
Vous aurez besoin de ce guide pour les instructions de sécurité, les
procédures d’utilisation et la garantie. Conservez-le dans un endroit sûr et
sec pour référence future.
PROD. NO. 013465
MOD. NO. SPT280
v.081118
Air Compressor & 2-in-1 Brad Nailer/Stapler Kit
Operators Manual (p.2)
Jeu de compresseur à air et
agrafeuse/cloueuse 2-en-1
Manuel de l’opérateur (p.12)
Question and Answer IconNeed help?

Do you have a question about the ITC SPT280 and is the answer not in the manual?

ITC SPT280 Specifications

General IconGeneral
BrandITC
ModelSPT280
CategoryAir Compressor
LanguageEnglish

Summary

Important Safety Instructions

Electrical Safety and Cord Use

Guard against shock, care for cords, use correct extension cords.

Personal Protective Equipment

Wear safety glasses/goggles and ear protection. Stay alert.

Compressed Air Cautions

Compressed Air Hazards

Air may contain CO, only compress air, use breathing protection when spraying.

Safety Precautions Specific to Compressor

Protective Devices and Components

Tank safety valve, pressure switch, and air tank protection from over-pressurization.

Safety Precautions for Nailer/Stapler

Air Pressure and Hose Requirements

Use clean, dry, regulated air; do not exceed pressure limits; use rated air hoses.

Clearing a Jammed Fastener

Procedure for Clearing Jams

Disconnect air, open magazine, remove jammed fastener using rod and pliers.

Compressor Maintenance

Pre-Maintenance Safety

Disconnect power and drain tank pressure before any maintenance.

Draining and Refilling Oil

Drain old oil, replace plug, refill with recommended oil to sight glass level.

Compressor Troubleshooting

Troubleshooting: Will Not Start

Check fuses, connections, extension cord, and motor overheating.

Nailer/Stapler Troubleshooting