ITC SPT700 User Manual

7
FRANÇAIS
ENGLISH
PARTS LIST
Please refer to the schematic drawing on page 15.
ITEM N
O
DESCRIPTION
1 Main spindle
2 M5 x 14 philips screw
3 M5 spring washer
4 Bearing block
5 6201 bearing
6 32 mm check ring
7 607 bearing
8 Gear
9 12 mm check ring
10 St5 x 30 philips screw
11 Reduction gear box
12 5 mm check ring
13 Spring
14 Lock pin
15 12 mm check ring
16 6201 bearing
17 Bearing pressure plate
18 5 mm circlip
19 M5 x 10 philips screw
20 Rotor
ITEM N
O
DESCRIPTION
21 607 bearing
22 Bearing sleeve
23 Orientation circle
24 St4 x 65 philips screw
25 Stator
26 Housing
27 Nameplate
28 Brush holder
29 Brush cover
30 Brush
31 Activator
32 Right handle
33 Switch
34 Left handle
35 St4 x 22 philips screw
36 Cord clamp
37 St4 x 14 philips screw
38 Cord protector
39 Plug and cord assembly
40 Front handle
ITC TOOLS AND EQUIPMENT (ITC) WARRANTY POLICY
All ITC branded products are guaranteed against defects in
workmanship and materials, when the product is used for
the purpose for which it was designed. Any ITC product that
fails during normal use and within the specied warranty
period for that product will be repaired or replaced at ITC’s
discretion.
ITC product warranties apply to ITC products purchased
new from an authorized ITC distributor
ITC product warranties are extended to the original retail
purchaser only.
See specic product warranty statements for more
information and limitations.
This warranty is void if there is evidence of misuse, abuse,
alterations, or normal wear and tear. Normal wear and
tear of moving parts can be repaired by purchasing the
appropriate ITC replacement part.
Go towww.itctoolscanada.com click on ITC Power Tools
Warranty for a list of authorized warranty repair centers.
No claim for indirect, incidental, or consequential, damages
of any type will be considered including loss time or wages,
loss of production. All products are sold with this specic
understanding.
Product for which there is a warranty claim must be
returned, freight prepaid to an authorized ITC distributor,
or in the case of machinery and hydraulic equipment, to
an authorized ITC warranty repair center. All returns must
include proof of purchase and an explanation of the defect
or failure.
2 Year Warranty
These products are designed for use in DIY (do-it-yourself),
light or intermittent duty, applications. They are not
intended for use in production, industrial or continual use
applications.
This warranty does not extend to normal wear or
consumable parts such as brad and staple gun driver
blades, grinding discs, saw blades, driver bits, electrical
motor brushes, worn cords, etc.
WARRANTY
www.itctoolscanada.com
®Registered trademark of JET Equipment & Tools. JET makes every effort to ensure that the information in this manual is current and accurate, however cannot accept responsibility and or liability for any loss or damage suffered as
a result of information contained herein. Products may be discontinued and specifications may be subject to change without notice. The trademarks, logos and service marks printed in this manual are registered and unregistered
Trademarks of this company and no trademark license either expressed or implied is granted by JET. Trademarks printed in this manual can not be used without prior written permission of JET.

ITC SPT700 Specifications

General

Brand	ITC
Model	SPT700
Category	Sander
Language	English