SERVICE MANUAL
E-37
Fig.9 Fig.10
Fig.11 Fig.12
14. Assemble lever (1) to pin (6) and set pin (6) using a driver and a pad.
See: fig.9 and 10.
15. Assemble pin (5).
See: fig.11.
16. Assemble lever (9).
17. Assemble pin (2).
18. Assemble bearing (13) and inner ring of bearing
(11) onto PTO shaft (12) using a pad.
19. Insert PTO shaft (12) using a driver and a hammer.
See: fig.12.
20. Assemble bearing (23) onto the cover (24) using tool CA716211.
See: sec. E.1 (PTO power take off).
21. Turn the cover (24) and assemble a new seal ring (26) using tool
CA716107.
See: sec. E.1 (PTO power take off).
22. Grease the seal ring (26).
See: See: sec. C.
ITL
To Next Page
Loading...