Itotec SC Series - How to adjust the knife height 2

5
box 1.
Remove the wrench and install the worm shaft.
Start the main motor.
then returns.
Install the new cutting stick.
Perform test cutting. If the lowest sheet remains uncut, adjust the knife height.
How to change the knife
Start the knife and check that the cutting edge slightly makes contact with paper and
Turn the clutch key counterclockwise to turn the clutch off. Close the door power electric
How to adjust the knife height ２
6.
7.
8.
11.
Be sure to remove the wrench.
Otherwise the turning wrench will cause injurues.
9 9
8
6
7
10.
9.
Set an unused face at the position where the cutting edge lowers.
If the cutting stick is lower the table face, place paper under the cutting stick
to check.
9 9
CAUTION
52