To Next PageTo Next Page
Need help?Do you have a question about the Itotec SC Series and is the answer not in the manual?
General| Brand | Itotec |
|---|---|
| Model | SC Series |
| Category | Paper Cutters |
| Language | English |
Using the correction function to adjust for print deviation and set correction on page.
Methods for inputting correction values or setting correction based on backgauge position.
Automatically setting correction by aligning marks and performing cutting.
Setting software limits for backgauge travel and viewing limits.
Initial steps for removing the knife, including safety precautions.
Continued steps for removing the knife, involving clamp and support bolts.
Further steps for knife removal, focusing on securing and detaching the knife.
Final steps for knife removal, including placing it in the storage box safely.
First part of the procedure for removing the knife with a knife lifter.
Second part of the procedure for removing the knife with a knife lifter.
Third part of the procedure for removing the knife with a knife lifter.
First steps for installing a new knife, including preparation and handle installation.
Continued steps for installing a new knife, involving holder and clamp operations.
Further steps for installing a new knife, securing it with bolts and adjusting height.
Final steps for installing a new knife, including bolt installation and lever position.
Initial steps for installing a knife using a knife lifter.
Second part of the procedure for installing a knife using a knife lifter.
Third part of the procedure for installing a knife using a knife lifter.
First steps for adjusting the knife height, including safety and initial movements.
Second steps for adjusting knife height, involving clutch and test cutting.
Detailed procedure for fine-tuning the knife height adjustment.
Steps to safely remove the false clamp from the machine.
Steps to safely install the false clamp onto the machine.
Procedure for removing the false clamp using the front installation method.
Procedure for installing the false clamp using the front installation method.
