Page|4
Button Functions
(1) POWER/REC/PLAY button
Use this button to turn the device manually ON/OFF and to manually start the recording. In playback
mode, this button has the PLAY function.
(2) & (5) Arrow key Up/Down – Right/Left button
Use the arrow keys to scroll the menu through the various points. While watching a video, they also
control the volume and the ability to zoom in or out.
(4) [Menu/OK] button
This button leads to the main menu, and when pressed and held again, will take you to sub-menu.
This button is also used to confirm menu selections. In video mode, it works to select between
Video/Photo mode as well as selecting a specific recordings or photos.
(8) [Lock key] button
Pressing this button during recording protects the current video from being overwritten.
(9) LED status indicator
Status display of the camera: blue light means the camera is on. Flashing red means that the camera
is recording. Steady red means the camera is in stand-by mode (switched on but not recording).
3. Assembly Instructions
In order to obtain an optimum view, it is recommended that the camera be positioned in the center of
the windshield and behind rear-view mirror. If the iTracker can’t be mounted behind the rear-view
mirror due to a lack of space, it can be mounted directly to either side (left or right) of the rear-view
mirror.
The camera should be positioned in such a way that the driver's visibility is not impaired. The iTracker
is attached to the mount and the camera may be removed from the mount by sliding the camera
upwards. Be sure you have sufficient room between the top of the camera and top of the windshield
so it can be removed before you secure it in place with the adhesive mounting plate.
The lens can be tiled up or down 45° and locked into position to ensure a uniform view. Once the
camera is turned on, look at the view screen and adjust the lens angle as necessary to obtain the
optimal view and tighten the locking knob.
When position the camera onto the windshield, be sure the camera is within the area cleared by the
windshield wipers to ensure the view is not obstructed during rain or snow conditions.
The car charger cable should not hang down in front of the driver. For your own safety, the cable can
be positioned under the inner roof lining of the vehicle and down along the A-pillars. It can also be
secured with cable clips attached along the windscreen. Cable clips are not included but can be
purchased separately.
To Next Page
Loading...