iTracker STEALTHcam - Switch-Off Delay

Page|7

Language
In this section you can change the language.
TV mode
Here you can select the TV mode. Choose between "PAL" (25 FPS *) and "NTSC" (30 FPS *). The
factory setting is NTSC. (* FPS: Engl.: frames per second, dt .: fps)
Frequency
LCD refresh rate, also known as display flickering.
Format
Formatting will deleted all records from the SD card. The SD card must be formatted before the
iTracker can record any data files. Always format the SD card in the iTracker.
Display shutdown
Here you can set whether and after how many seconds/minutes the screen goes blank.
Switch-off delay
Here you can specify after how many seconds the iTracker will shut down once power is lost.
Factory settings
When selecting and confirming this setting, the camera is reset to the original factory settings.
Firmware Version
Information about the firmware version is provided.
Menu description in photo mode
If you wish to create photos with the iTracker, so you can use the Photo mode. Press the [M/OK]
button between the arrow keys to navigate to Recording Mode. In Recording mode, the timer can be
set. In "single" a single photo is taken directly, otherwise a picture will be taken every 2, 5 or 10
seconds.
Resolution
Resolution of the photos is provided.
Resume
When "On" the iTracker will take five photos in sequence.
Quality
Sharp, normal or economical photo quality can be selected.
Sharpness
You can adjust the picture sharpness.
White Balance
Depending on the lighting you can set a lighting mode. We highly recommend leaving this set to
"Auto" to ensure the system will adjust automatically.