iTracker STEALTHcam - Page 8

Page|8

Color
You can add an effect to the image (for example, "sepia").
ISO
Allows adjusting the brightness of the image.
Exposure
Here you have the possibility to change the brightness of the recordings. This setting is centrally
confirmed by the icon on the left, so you always have a value in mind.
Stabilization
This setting allows for image stabilization.
Fast forward
It is set whether and how long the photo after the snapshot displayed on the screen becomes.
Date Stamp
Here you can set whether the photos should be created with or without a date stamp. To exit the
menu press and hold the [Menu/OK] button twice in succession 2 seconds each.
Menu description in photo mode
First, connect the camera to the cigarette lighter of the vehicle using the supplied car charger cable.
After switching on the ignition of the vehicle, the camera automatically turns on and starts recording.
The recording is confirmed by a red flashing dot on the display.
If the device is already switched on, recording will be paused when you press the [REC/PLAY] key.
Press the [REC/PLAY] button to start recording again.
To protect a specific recording from being overwritten, press the red [LOCK] button below the display.
A key appears in the left edge of the display and this recording is blocked and the file cannot be
overwritten. The locked videos can only be removed by formatting the memory card. By pressing the
[Menu/OK] button for 2 seconds, you can switch between Video mode, Photo mode and change
preview mode.
In preview mode, you can record videos or photos or play and view them. Use the arrow keys [< >]
to switch between the recorded videos/photos or various menu items in the settings.
By pressing the [REC/PLAY] button the video you want will play on the display screen after a short
delay. From the submenu, you can use the [Menu/OK] button [Open] button to open and play the
selected file. Use the arrow keys [< >] to change the volume.
First, connect the camera to the cigarette lighter of the vehicle using the supplied car charger cable.
After switching on the ignition of the vehicle, the camera automatically starts and begins recording. A
red flashing dot on the display confirms the iTracker is recording.
Videos/photos or other menu items in the settings.
By pressing the [REC/PLAY] button the video you select will play on the display after a short delay.
In the submenu use the [Menu/OK] button. You can also use the arrow keys [< >] to regulate the
volume of the video.