5
Include in it the house, roads, garden, pool, etc. If your neighbors have the same system installed, include it in the drawing as well.
It can withstand temperatures below freezing, but it is not waterproof! So it is best to place the transmitter in a closed area.
Static correction
Shy to average
High correction
Draw the expected wire route in the drawing. This will allow you to install it later more easily. For the system to work, the wire must form one closed
loop.
Low static correction
4 flashes
A. Schematic drawing
Step 2
Install the transmitter at least 1 m away from large metal objects (e.g. boiler, iron gate, washing machine). When installing the transmitter,
make sure that the cable cannot be broken by doors, windows or gates. When drilling holes, make sure that there are no electrical cables,
screws or nails in the drilling area.
2 flashes
3
Preparation of the project of the bounded area
Since the transmitter must be installed in an enclosed space protected from rain, pay attention to the wire outlet from the interior. Existing
openings such as doors, pipes, or windows may be suitable as long as there is no risk of interruption. Another option is to drill a hole in a
suitable place.
Temperament of the dog
Very energetic
5 flashes
1 blink
3 flashes
The transmitter can be placed on the wall near any common household outlet using the included screws.
Receiver function
Average to energetic
4
B. Determine the location of the transmitter (base)
Medium high correction
Prepare a drawing of the area you want to fence. The drawing will help you avoid unpredictable obstacles.
Draw the cable route in the drawing
Indicative light response
Shy
1
Medium static correction
Step 1
C. Determine the exit point of the buried wire from the ground to the transmitter
No static correction, just a beep
2
How correction works
1. Warning before correction - tone: when the dog reaches the edge of the signal field, a warning tone will be
heard, which lasts 4 to 10 seconds. If the dog does not return to the safe area, it will receive a
continuous correction and a small shock until it returns to the safe area.
Press and hold the mode button continuously for 3 seconds. You will hear a separate beep to indicate that
the receiver has turned off.
Turn off the receiver
signal field. The dog cannot run through the signal field without receiving a strong correction.
2. Overrun protection: the receiver automatically increases the correction as soon as the dog enters the
Part 1 - System Setup Instructions
To Next Page
Loading...