To Next Page
H
hroyAug 16, 2025
Why does my ITV SPIKA NG 125 Ice Maker unit run and stop intermittently?
- JJoshua WilsonAug 16, 2025
The safety pressure switch may be opening. To resolve this, clean the air condenser located behind the front grid.
Why does my ITV SPIKA NG 125 Ice Maker unit run and stop intermittently?
The safety pressure switch may be opening. To resolve this, clean the air condenser located behind the front grid.
Why is my ITV SPIKA NG 125 production so low?
A dirty condenser can cause low production. Clean the condenser and check the incoming water/air temperature.
What to do if my ITV SPIKA NG 125 electrical parts don't work?
If none of the electrical parts are working, the machine might be unplugged. Plug in the machine and verify that the socket has power.
What to do if my ITV SPIKA NG 125 unit stops after running for a short time?
The safety pressure switch may be opening. You should clean the air condenser, which is located at the back of the unit.
What to do if my ITV Ice Maker bin is full but the machine doesn't stop?
The bin thermostat may not be opening, as it should only operate during harvest time. Adjust the thermostat, which is located in the electric box under the top cover.
How to fix not uniform flow pattern at evaporator in ITV SPIKA NG 125?
A non-uniform flow pattern at the evaporator can be caused by a dirty or scaled distributor. Perform a descaling procedure and then remove and clean the distributor by pulling it from the two clips on its sides.
What to do if my ITV SPIKA NG 125 Ice Maker ice slab is empty or too thick?
An empty or overly thick ice slab may be due to a desadjusted cycle time. Adjust the thermostat located in the electric box under the top cover.
Why is it difficult to release ice slab at harvest in my ITV SPIKA NG 125 Ice Maker?
If it's difficult to release the ice slab during harvest, the unit might not be leveled correctly (tilted to the back). Level the unit, lowering the front.
What to do if my ITV SPIKA NG 125 Ice Maker doesn't have enough water to end cycle?
If there is not enough water to end the cycle, the water level probe may be too low. Move the steel rod beside the pump upwards.
Why is there not enough harvest time on my ITV SPIKA NG 125 Ice Maker?
Add more pins to the cam timer wheels, as indicated on the label.
General
