ITW Simco-Ion ST-4 - Equipment Receipt and Packing; Receipt of Equipment Instructions; Packing Articles and Accessories List

INST-10121514
Thank you for buying Simco products. This equipment will meet your expectations and
provide safe operation when it is properly installed and maintained.
Receiptofequipment
Please carefully remove the equipment from the carton and inspect. Note any damage that
might have occurred during shipment. Empty the carton to ensure that small parts are not
discarded.
If any damage has occurred during shipment, the local carrier should be notified at once. A
report should be forwarded to SIMCO JAPAN, INC. The address and other relevant
information are written on the back cover page.
Packing articles and accessories
1 Worksurface Tester Model ST 4 ....................................................... 1 pc.() -
2 Probe Assembly cable .......................................................................... 1 pc.()
Cable length 850 , banana plug alligator clip㎜、
3 Instructions / Warranty ....................................................................... 1 pc.()
Option:
1 USB Cable ........................................................................................... 1 pc.()
2 USB-AC ADAPTER ........................................................................... 1 pc.()
3 C ......................................................................................... 1 pc.()
arrying case
Please check if any part is missing or does not
have satisfactory finish. Contact us or our agents
immediately in the event of such occurrence.
-page2-
INST-10121514
Contents
Notes to Users ......................................................................................... page 1
Receipt of equipment............................................................................... page 2
Packing articles and accessories.............................................................. page 2
Contents.................................................................................................... page 3
Section 1. Description ............................................................................. page 4
Section 2. Principle of measuremen ....................................................... page 4
Section 3. Specification ........................................................................... page 5
Section 4. Setup ....................................................................................... page 6
Section 5. Operation ................................................................................. page 7
Section 6. Exponnent less than a decimal point ..................................... page 8
Section 7. Probe Cleaning ........................................................................ page 8
Section 8. Dimensional drawings ............................................................ page 9
SIMCO EQUIPMENT REPAIR WARRANTY...................................... enclosed
Explanation of Symbols:
WARNING
ATTENTION / CAUTION
ELECTRIC SHOCK HAZARD
-page3-