Set to System Address A (S1 = OFF, S2 = OFF)
Set to Tool Address A2 (S4 = OFF, S5 = ON, S6 = OFF)
Set Delay Time to 5sec (S3 = ON)
Test it manually - Open / Close Gate A2
Set Delay Time to your preference
Set Mode to Auto - Ready to work with other iVAC modules
Set to System Address A (S1 = OFF, S2 = OFF)
Set to Tool Address A2 (S4 = OFF, S5 = ON, S6 = OFF)
Test it manually - ON / OFF to control Gate A2 and Switch A
Test Auto Mode with tool A2 to control Gate A2 and Switch A
Set to System Address A (S1 = OFF, S2 = OFF)
Set to Tool Address A2 (S3 = OFF, S4 = ON, S5 = OFF)
Test it manually - ON / OFF to control Gate A2 and Switch A
Set to System Address A (S1 = OFF, S2 = OFF)
Set to Tool Address A3 (S4 = ON, S5 = ON, S6 = OFF)
Set Delay Time to 5sec (S3 = ON)
Test it manually - Open / Close Gate A3
Set Delay Time to your preference
Set Mode to Auto - Ready to work with other iVAC modules
Set to System Address A (S1 = OFF, S2 = OFF)
Set to Tool Address A3 (S4 = ON, S5 = ON, S6 = OFF
Test it manually - ON / OFF to control Gate A3 and Switch A
Test Auto Mode with tool A3 to control Gate A3 and Switch A
Set to System Address A (S1 = OFF, S2 = OFF)
Set to Tool Address A3 (S3 = ON, S4 = ON, S5 = OFF)
Test it manually - ON / OFF to control Gate A3 and Switch A
To Next Page
Loading...
