Assembly:
Water supply
Switch
Water inlet
Water oulet
Recommended Process:
(1) Hose to gun → (2) hose to water outlet → (3) water inlet hose to quick
connector attaching to unit → 4) water inlet hose to tap → (5) spray wand
to gun. Set the wand to low pressure step. Open the tap and trigger the gun to
remove the air in the unit. Connect to power. Turn on the appliance. Set to
high pressure.
Locked position: locking button on the side of
the handle protrudes; trigger is locked.
Locking button pressed in; trigger is unlocked.
7
To Next Page
Loading...