Iveco IVECONNECT - Iveconnect Applications Update

I VECONNECT - P ROCEDURE FOR Software Update VIA USB PENDRIVE
3
/
4
Congratulations, you have successfully completed the Iveconnect System Update .
IMPORTANT NOTE:
In case of issues during the update procedure read what reported below:
• Update not started. In case the warning message is missing and/or the system is not restarted
at step C, hold down CD-EJECT button for 10sec, then release it.
In this way a system restart is forced and the update procedure should start.
• Failure during the update procedure. In case the update fails, the display will show the
image below with the reason of the failure. In this case, please, unplug the USB and hold down
the CD-EJECT button for 10 sec and restart the update procedure again.
Figure 5 – Error during the Update procedure
If problem persists, please take note of the information reported and contact the Iveco service
network for additional support.
Iveconnect Applications Update
The USB Pendrive to use for the Update procedure has to be empty and formatted. In case you wish to use
the same Pendrive previously used for the Iveconnect System Update, please ensure the 3 files previously
copied are deleted.
Uncompress the 4 files contained in the compressed archive XXXX_pack2.zip and copy them in
the root folder of the USB Pen Drive; these 4 files are named as follows:
1. “ANS.app”
2. “DSE.app”
3. “QC_MMI.app”
4. “applications.cfg” .
Please ensure all 4 files are present then follow the steps outlined below to start and complete the
Iveconnect Applications Update:
A. With the Home screen displayed, insert the USB pen-drive on the USB connector on the upper
shell (see Figure 2).
B. Wait until the reboot notification windows is displayed and answer yes to the request to restart
the Iveconnect system. As soon as the system is restarted, the applications installation procedure
will start and a screen similar to the one reported below will appear.