15
EN
Instruction manual
TROUBLESHOOTING
CAUTION! Turn off the engine and wait until the machine stops completely before
investigating fault.
Conventional trouble Trouble reason Remedy
The engine (4) does not start
∙ The machine ran out of fuel.
∙ There is dirt or water in the
carburetor tray.
∙ The spark plug (23) is wet,
faulty, fouled or improperly
positioned.
∙ The fuel tank (17) is clogged.
∙ The carburetor isn’t reached by
the fuel.
∙ Add fuel.
∙ Empty the tray removing the
nut.
∙ Remove and inspect the spark
plug (23); dry and clean any dirt
away from around the spark plug
(23); reinstall the spark plug (23) or
replace if necessary.
∙ Clean it.
∙ Clean the fuel sediment cup
(22).
The engine (4) starts, then stops
∙ The fuel cap bleed valve is
blocked.
∙ The air lter (19) is dirty.
∙ The machine ran out of fuel.
∙ The spark plug (23) is wet,
faulty, fouled or improperly
positioned.
∙ Clean it.
∙ Clean it.
∙ Add fuel.
∙ Remove and inspect the spark
plug (23); dry and clean any dirt
away from around the spark plug
(23); reinstall the spark plug (23) or
replace if necessary.
If the engine (4) stops
∙ Engine (4) is overloaded.
∙ The air lter (19) is dirty.
∙ The machine ran out of oil.
∙ The spark plug (23) is wet,
faulty, fouled or improperly
positioned.
∙ The fuel tank (17) is clogged.
∙ The mufer is clogged.
∙ Limit the work depth using the
handlebar (10).
∙ Clean it.
∙ Add oil.
∙ Remove and inspect the spark
plug (23); dry and clean any dirt
away from around the spark plug
(23); reinstall the spark plug (23) or
replace if necessary.
∙ Clean it.
∙ Clean or replace it.
The shaft does not turn or has no
torque
∙ Throttle lever (11) is not
properly adjusted.
∙ Tilling is too deep.
∙ Shear pin(s) is broken.
∙ Check throttle lever (11)
control setting.
∙ Limit the work depth using the
handlebar (10).
∙ Replace shear pin(s).
If the problem cannot be remedied on the basis of the information above, please take the device to an authorized
IVT Service Center.
ATTENTION! DO NOT ATTEMPT TO REPAIR THE PRODUCT BY YOURSELF AND DO NOT
TAMPER WITH IT! Any operation of repairing or extraordinary maintenance must be carried
out only by a qualied and authorized IVT Service Center. Do not try to modify any internal
part of the product! THIS WILL COMPLETELY VOID THE WARRANTY AND IT COULD CAUSE
SERIOUS INJURY AND DAMAGE.
To Next Page
Loading...
General