Settings
6 720 645 172 (2010/07) en
18
4.5 Settings\Hot water
Setting Factory Range HP
Hot water
Hot water type No hot water No hot water
Local sensor
Communicated
Previous HP
E2x
Not E21
When the heat pump is to produce hot water:
B Enter how the heat pump is to control hot water production.
B Select Local sensor when there is a locally connected hot water cylinder with local sensor to
measure the hot water temperature.
B Select Previous HP when the heat pump receives values for the hot water temperature from
the previous heat pump.
B Select Communicated when the heat pump has all information about the hot water
temperature and start/stop limits via communicating (Modbus) control (Æ Chapter 4.1,
page 10).
Temperatures
Actual v.:
Start:
Stop:
Max temperature:
Display
53 °C
57 °C
Display
E2x
B Set start and stop values for hot water production.
The factory settings refer to heat pumps with Local sensor. In Previous HP 2 K lower
temperatures are recommended. In Communicated the values have no meaning.
Max temperature displays the calculated possible highest hot water temperature.
Tab. 36 Hot water
To Next Page
Loading...
Need help?
General