9
Warning:
Do not charge device for more than 12 hours.
1. Power o the Rincon
2. Connect the Rincon to a USB wall plug
3. A green/blue and a red light will show; the green/
blue light will turn o after 3 minutes (memory card
inserted) or after 10 seconds (no memory card
inserted)
4. The red light will show during charging and power
o when fully charged
C. INSERT MICRO SD CARD
To access the SD card slot, lift the rubber cover
on the left arm of the glasses. For best results, we
recommend a class 10 micro SD card. The Rincon
supports up to a 128GB SD card. (Purchased sepa-
rately)
1. Power o the Rincon
2. Lift the cover on the left arm of the Rincon
3. Insert a micro SD card into the slot until you feel it
click into place
4. The slot is spring loaded; to remove the card,
push it down until you feel it release
D. POWER ON/STANDBY/OFF
The power button is on the rubber cover on the left
arm of the Rincon.
1. To turn on, press the power button; the Rincon
will vibrate twice
2. A ashing blue or green light will show indicating
that recording has started (blue=1080P, green=720P)
3. To enter standby mode, press the power button
once; it will vibrate and enter standby mode (in this
To Next Page
Loading...