What to do if my IWAKI EWN-C21 VC is leaking?
If your IWAKI Water Pump is leaking liquid, first, retighten the fitting or the air vent body if they seem loose. If the pump head is loose, retighten it. Ensure that O rings and valve gaskets are properly installed. If the diaphragm is broken, replace it. Finally, check that the discharge line is not closed or the tubing is not clogged, as excessive discharge pressure can also cause leaks.
Why does the flow rate fluctuate in my IWAKI EWN-C21 VC?
If your IWAKI Water Pump's flow rate fluctuates, it could be due to several reasons. Air might be trapped in the pump head, so try to expel it. Overfeeding might be occurring, in which case you should mount a check valve. Foreign matter could be stuck in the pump head valves, requiring you to dismantle, inspect, and clean the valves, replacing them if necessary. A broken diaphragm can also cause this issue, so consider replacing it. Lastly, pressure fluctuations at the injection point can be a factor; maintain a constant pressure by optimizing piping or relocating the injection point.
What to do if my IWAKI Water Pump cannot pump up liquid?
If your IWAKI Water Pump isn't pumping liquid, there might be an air lock in the pump, so you should expel the air. If the stroke length is too short, run the pump at 100% stroke length and adjust it to the proper length. Also, check for air ingress through the suction line and correct the tubing if needed. Ensure that the valve set is installed correctly and that valve gaskets are in place. Finally, check for any foreign matter stuck in the pump head valves or a ball valve stuck on a valve seat; dismantle, inspect, and clean the valves, replacing parts as necessary.
What to do if my IWAKI Water Pump does not receive the external signal?
If your IWAKI Water Pump does not receive the external signal, check the wiring to ensure the signal is being sent to the pump.
How to store EXT mode programming on IWAKI EWN-C21 VC Water Pump?
To ensure that the EXT mode programming is stored to the IWAKI Water Pump, push the start/stop key after programming.
Explains warning and caution symbols used to indicate risks and precautions.
Details critical safety instructions such as turning off power, wearing protective clothing, and avoiding hazardous environments.
Lists general precautions for installation location, vibration, and handling chemicals.
Introduces the pump series and explains its fundamental operating mechanism.
Highlights pump features, operational functions, part names, and the operational panel.
Explains display indicators, pump states, and model identification codes.
Provides instructions for pump mounting and connecting tubing to inlet/outlet ports.
Details check valve installation and guidelines for power voltage, earthing, and signal wiring.
Covers pre-operation checks, bolt tightening, degassing, and flow rate adjustment.
Explains programming for manual, EXT, multiplier, divisor, and analogue modes, plus user mode configuration.
Details STOP/Pre-STOP functions, OUTPUT signals, ANA-V/-R selection, Buffer, PIN entry, Keypad Lock, and Calibration.
Provides solutions for common problems and guides daily/periodic pump inspections.
Details replacement for valve sets, diaphragms, air vent valves, and spacer sets.
Shows exploded views of the pump assembly and detailed parts of the pump head.
Details technical specifications like flow rate, pressure, power, and weight for various models.
Provides dimensional drawings and measurements for different pump models.
General| Brand | IWAKI |
|---|---|
| Model | EWN-C21 VC |
| Category | Water Pump |
| Language | English |
To Next Page
