To Next PageTo Next PageWhy are there bubbles in the color cup of my Iwata High Performance Plus?
Bubbles in the color cup or bottle of your Iwata Airbrush can be due to a few reasons. First, make sure the nozzle cap is tightened finger tight. It could also be caused by an improper connection between the nozzle and head nozzle base. Another cause might be a cracked or damaged nozzle.
Why is my Iwata Airbrush not spraying?
If your Iwata Airbrush is not spraying, first, ensure the needle chucking nut is finger tight. If the needle is stuck, try to gently pull it out to free it. Also, check that the air pressure is set correctly according to your compressor's instructions. Make sure your paint isn't too thick and that the nozzle isn't clogged. A cracked or damaged nozzle can also prevent spraying.
Why is my Iwata High Performance Plus skipping?
Skipping with your Iwata Airbrush can occur due to dried paint on the needle tip, paint that is too thick, or an improper connection between the nozzle and the head nozzle base. A dirty airbrush, or a cracked or damaged nozzle can also cause skipping.
Why does the main lever stick up and down on my Iwata Airbrushes?
If the main lever on your Iwata Airbrush sticks in the up and down direction, this could be caused by paint on the air valve packing o-ring.
General| Brand | Iwata |
|---|---|
| Model | High Performance Plus Series |
| Category | Airbrushes |
| Language | English |
Describes the HP-A Plus model, H2 head system, and fluid capacity.
Describes the HP-B Plus model, H2 head system, and gravity feed fluid cup.
Describes the HP-C Plus model, H3 head system, and gravity feed cup.
Describes the HP-BC Plus model, H3 head system, and siphon feed configuration.
Describes the HP-SB Plus model, H2 head system, and side feed color cup.
Discusses compressor requirements for the High Performance Plus Airbrush Series.
Steps for assembling and connecting the airbrush to a compressor.
Techniques for achieving wide lines and blending with the airbrush.
Explains the function of the preset handle for volume control.
Describes how to use the cutaway handle for quick clog removal.
Instructions on how to create stippling effects with the airbrush.
Guidance on recommended air pressures for spraying.
Advice on preparing paint for optimal airbrush performance.
Important safety precautions for using the airbrush.
Steps for cleaning the airbrush when changing colors for specific models.
Steps for cleaning the airbrush between colors for the BC+ model.
Detailed instructions on how to clean the airbrush needle.
Procedure for lubricating the needle for smooth lever action.
Steps to lubricate the air piston for specific models.
Steps to lubricate the air piston for the BC+ model.
Solutions for air bubbles in the paint cup or bottle.
Causes and solutions for producing a double line spray pattern.
Troubleshooting steps when the airbrush is not spraying.
Solutions for intermittent paint flow or skipping spray.
Addressing issues causing paint spattering.
How to fix a main lever that sticks during operation.
How to resolve a main lever that sticks in the up/down direction.
An illustrated breakdown of the airbrush components.
A detailed list of parts and their compatibility across models.
Instructions for replacing the airbrush nozzle.
Information on handling and replacing the airbrush needle.
Details about the optional crown cap accessory.
Information on the optional quick disconnect feature.
Details on the optional pistol-grip moisture filter.
