TROUBLESHOOTING
Compressor turns on and o while airbrush is not spraying air. The compressor has an air leak somewhere. When this happens, try the
following steps:
1. Spray all connections with a soapy solution. Resulting bubbles indicate an air leak.
2. Tighten connections.
3. If bubbling doesn’t stop, try wrapping threads with thread sealant tape (max 3 wraps only) or applying beeswax to the threads.
Both methods provide an airtight seal.
4. If the air leak is in the middle of a hose the hose will need to be replaced.
For any other problems or issues call or contact ANEST IWATA-MEDEA at 503-253-7308 or email at: info@iwata-medea.com
13
To Next Page
Loading...
