44
Chapter 4 BIOS Setup
If the system is no longer able to boot after changing the settings,
the only way to recover it is to clear the data stored in RTC CMOS.
To reset the RTC CMOS data, take the JP1 jumper cap off pins 1-2,
place onto pins 2-3, and then place back onto pins 1-2 again. This
will return the RTC to the default setting. Then, get into the BIOS
setup program , choose Load Fail-Safe Defaults ; Load Optimized
Defaults, and select the original manufacturer default settings in
your CMOS.
4.2.3 Using BIOS setup program
ÇUp Move to the previous field
ÈDown Move to the next field
ÅLeft
Move to the field on the left hand
side
ÆRight
Move to the field on the right hand
side
<Esc>
Quit from setup program without
saving changes, or Exit from
current menu page and return to
main menu page
<PgUp> or
<+>
Select the previous value for a field
<PgDn> or <-> Select the next value for a field
<F1> General Help
<F2> Item Help
<F5> Previous Values
<F6> Fail-Safe Defaults
<F7> Optimized Defaults
<F10>
Save the current value and exit
setup program
To Next Page
Loading...