82
Chapter 4 BIOS Setup
4.14 Set Supervisor/ User Password Setting
These setup pages are used for password setting. When a
password has been enabled and the Security Option field is set as
Setup, you will be required to enter the password every time you try
to enter BIOS Setup program. This prevents an unauthorized
person from changing any part of your system configuration.
Additionally, if the Security Option field is set as Boot, the BIOS will
request a password every time your system boot. This would
prevent unauthorized use of your computer.
In you wish to use this function, bring the cursor to this field, then
press <Enter>. The computer will display the message, “Enter
Password”. Type your password and press <Enter>. After the
message onfirm Password” is displayed, re-type your password.
The Supervisor Password function will be in effect after you save and
exit setup.
To disable a password, bring the cursor to this field, then press
<Enter>. The computer will display the message, “Enter
Password”. Press <Enter>. A message will confirm that the
password is disabled. Once the password is disabled, the system
will boot and you can enter setup program freely.
To Next Page
Loading...