Need help?Do you have a question about the IXXAT CAN@net and is the answer not in the manual?
Outlines the initial steps required to prepare the CAN@net for configuration using a terminal program.
Details the procedure for putting a configured CAN@net device into operation after setup.
Presents a table summarizing network and hardware parameters, their types, pre-settings, and comments.
Explains how to start the configuration dialog via a serial interface and terminal program.
Guides through configuring network settings like DHCP, IP address, subnet mask, and gateway address.
Covers hardware-specific settings such as baud rate for the serial interface and configuration dialog delay.
General| Category | Gateway |
|---|---|
| Interfaces | CAN, Ethernet |
| Ethernet Ports | 1 |
| Weight | Approx. 200 g |
| Protocol Support | CAN, TCP/IP |
| CAN Channels | 1 or 2 |
| Configuration | Web interface, configuration tool |
| Ethernet Interface | 10/100 Mbit/s |
To Next Page
