J/133 OWNER GUIDE 39
• Ground Fault Systems: There is a single ground fault system on the J/133 that protects all AC
outlets.
Galley Stove LPG System
Liquid Propane Gas (LPG) is the most common fuel used for boating and is available at most marinas in
the U.S. The standard Force 10 stove/oven is of very high quality and is engineered for the marine
environment in high-grade stainless steel. It is comparable to a home range.
The biggest difference is safety. While the home gas stove utilizes a petroleum gas which is lighter than air
(it disperses easily if there is a leak), the propane stove utilizes a gas which is heavier than air, and thus,
sinks to the bottom of enclosed compartments. All J/Boats equipped with LPG stoves utilize a safety
system prescribed by ABYC and USCG guidelines. This includes an independently vented and sealed
compartment for the tank, an electronic solenoid shut-off valve, a regulator, and approved LPG hose.
• Propane Tank: The standard 6 lb capacity LPG tanks (2) are located in a specially designed
compartment located outboard of the wheel to starboard in the J/133. This box is designed to
accommodate (3) 6 lb. LPG bottles, is sealed and ventilates and drains over the side to specifically
eliminate the accumulation of dangerous gases.
• LPG Gauge: installed within the propane locker measures the amount of pressure left in the tank.
• Solenoid Cap Valve: is located on the hose in the propane compartment. It electronically shuts-
off the flow of gas at the tank. This valve is a “normally closed” valve; therefore electrical power
must be provided through the breaker switch at the panel so that gas can flow to the stove.
• Regulator: is located on the hose in the propane compartment. It is a screw down valve that
regulates the flow of propane into the system.
Stove Operation
• Check that all burner (including oven) knobs are off.
• Check manual valve on tank and open.
• Ensure battery switch is on and 12 volt power available.
• Turn on solenoid valve breaker on the electrical panel.
• Open burner valve on stove slightly and light burner. Always apply flame or sparker to burner
before opening valve.
When Cooking Is Complete
• Turn off solenoid valve switch on electrical panel first to shut-off supply of gas at the tank.
• After flame of burner goes out, turn off knob for burner (this purges gas from lines).
• Firmly close manual valve on tank—DO THIS EVERY TIME!!
To Next Page
Loading...
Need help?
General
