10
english
JABRA CLIPPER
I cannot hear the phone call in the headset
- Increase the volume on the Jabra CLIPPER.
- Make sure your phone is connected to the headset by i.e.
tapping the Multi-Function button, or viewing the LED
indicator.
I have pairing problems
- You may have deleted the pairing connection in your mobile
phone – follow the pairing instructions in ‘Pair Your Headset to
a Phone or other Device ‘.
I cannot use Reject call or Redial
- These features are dependent on your phone supporting them;
please consult your phone’s manual for details.
I cannot hear music in the headset
- Ensure that the headset is connected to your Bluetooth®
enabled device.
- You may have been out-of-range (10 meters) to your Bluetooth®
enabled device or the headset might have experienced an ESD
(Electrostatic discharge) incidence. Press the Multi-Function
Button to re-establish the Bluetooth® audio link - Increase the
volume on your device.
- Make sure that the Jabra CLIPPER is charged.
The music I hear sounds very poor
Make sure the other device supports Bluetooth® 1.1 or higher
including the Advanced Audio Distribution Profile (A2DP) for
music streaming.
If the above procedure did not help then it is possible that your
phone is using the stereo audio connection in a different way. You
can enable this mode on Jabra CLIPPER by performing pairing in
the following way:
- Remove the Bluetooth® connection to Jabra CLIPPER on your
phone.
- Make sure the headset is on.
- Press and hold the Multi-Function button for more than 5
seconds until the LED display are solid Blue.
- Go through the regular steps in pairing the headset to a
Bluetooth® device.
To Next Page
Loading...
Need help?
Battery
Connectivity
