jabra
GN1000
RHL
Pick up and hang up without going
back to your desk!
Enjoy full wireless freedom!
Add the Jabra GN1000 Remote Handset Lifter to
your Jabra wireless headset system, and you’re
completely free to roam. With the Jabra GN1000
RHL, you can answer calls, and end them, from
wherever your wireless headset takes you.
Two minutes to set up
Unlike some handset lifters, the Jabra GN1000
RHL is incredibly easy to install. A few simple
steps, and you’re ready to go.
One-button operation
It’s incredibly easy to use, too. When you hear the
ring tone, you push a button. The Jabra GN1000
RHL immediately lifts the handset and connects
the call. At the end of your call, just push the
button again to hang up.
Technology you can trust
Most handset lifters respond to sounds within a
certain frequency range. If they’re not perfectly
adjusted, you can miss calls or be signalled when
there isn’t a call. But the Jabra GN1000 RHL senses
the magnetic eld the speaker generates when
your phone rings, which means it’s virtually
foolproof. So you never miss a call.
No compatibility or reliability worries
The Jabra GN1000 RHL’s design is based on a
comprehensive study of telephone measurement
specications, so it works with over 90% of all
business telephones. Unless your phone has a
truly unusual design, it will work. And since the
Jabra GN1000 RHL has been tested to lift and
lower the heaviest handsets 100,000 times, you
know it will keep working. For a good long time.
Jabra GN1000 RHL
Remote Handset Lifter
shown above connected
to a business phone base.
To Next Page
Need help?
General
Weight and Dimensions
