Jack Richeson LOBO - User Manual

HOW TO ASSEMBLE THE
Imported Easels by Jack Richeson & Co., Inc. - Kimberly, WI - Phone: 1-920-738-0744 - www.richesonart.com 7/13
A. Easel
Frame
With Mast
1. 2 - Slide Guides
2. 2 - Knobs (with bolt)
3. 2 - Plastic Washers
4. 3 - Wood Screws
5. 2 - Brass Washers
6. 1 - Knob
7. 1 - Bolt
8. 1 - Slide Guide
9. 1 - L-Bracket
10. 2 - Wood Screws
11. 1 - Knob (with bolt)
Step One:
Attach the Easel
Frame (A) to the
Base (C), with the
hardware in Parts Bag 1.
Thread the Knob (with
bolt) through the Plastic
and Brass Washers, the
Base leg, the Slide Guide,
and into a recessed nut
on the Easel Frame.
Tighten. Repeat on
other side.
C. Base With
Shelf
B. Back
Support
Leg
1 2
3 4 5
Parts Bag 1
Parts Bag 2 Parts Bag 3
6
7
8
9
10
11
Step 1
Step Two:
Using the 3 screws from Parts Bag 1, mount the hinge on
the Back Support Leg (B) using the pre-drilled holes on the
back of the Base (C).
Step Two
You may select any of the 5 height
positions for your easel frame.
Pre-drilled
hinge holes
for Step 2.
Lobo Easel
#883201 Made from Lyptus
®
Wood
Lyptus
®
is a registered trademark of Weyerhaueser.

Summary

Lobo Easel Assembly Instructions

Parts Identification

Lists components included in Parts Bags 1, 2, and 3 for easel assembly.

Step One: Attach Easel Frame to Base

Connects the easel frame (A) to the base (C) using specified hardware and washers.

Step Two: Mount Hinge on Back Support Leg

Secures the hinge to the back support leg (B) using pre-drilled holes on the base (C).

Step Three: Join Hinged Support Legs

Connects the hinged support legs using the slide guide system, bolt, and knob.

Step Four: Attach L-Bracket to Mast

Mounts an L-bracket to the adjustable mast for holding it upright, using wood screws.

Step Five: Adjust Mast Height

Inserts a knob with bolt to set and secure the desired height of the adjustable mast.

Jack Richeson LOBO Specifications

General

Brand	Jack Richeson
Model	LOBO
Category	Indoor Furnishing
Language	English