1.3 Reset to Factory Defaults Parameter
When the control box cannot work or parameter set abnormal, and panel shows E5/E7 error
code, user can reset factory defaults to set.
The panel shows “P”, press “-” for 3 seconds, and the panel shows “OK”, then stop. This means
set successfully. Panel shows “Er” means failure. Check other reasons.
1.4 Error Solve with one Button
When the panel shows Er code, machine cannot work, press and adjust which error code. If
the Er code still exist, the panel still show the error code. If the problem solved, it will back to P.
III. OPERATION REPEIREMENTS
1. Please check the control-box far away magnetic or high radiation environment in order to
avoid obstructions.
2. The operational temperature must be in the range of -5℃--40℃.
3. Please don’t use this product near to any kind of heater(heat, radiator).
4. Please don’t use this product in over-wet circumstances.
5. Please don’t use this product under the corrosive and explosion situation.
6. Keep ventilation where the control-box and motor stored.
7. Keep the power supply voltage steady.
8. There must be qualified connector to the ground in order to make sure safety.
IV. MANTAINANCE AND GENERAL RECOVERY PROCESSING
If the machine went wrong, maintenance and operation should be operated under professional
trained person.
1. No reaction when turn on the power control box.
Please check if the power plug connected to the socket tightly, or the fuse is burnt, if yes, change
the fuse. Open the cover of the control box first, then find the position of fuse, take the burnt
fuse out and change a new one which as the same type as before.
2. Control box is connected, but the motor doesn’t work when pressing the pedal.