Standard：This adjustment is same as 781D serie.
mode and Number Comparison
1/2
1
5/4
1/2
：
Method：
1. Pull out the part, put up the canning.
2. Loose the screw, let the pointer front to the number you need. （The number
should be same as length of cutter) Then tighten the screw。
18.0：Adjustment of the button hole length
Feeding Crank
Loose screw
Pointer
Notice：After change the number on dial, then
should change the presser foot similar as the
length of button hole.
To Next Page
Loading...
