en-60
JACOBSEN AR3
SAFETY, OPERATORS & MAINTENANCE MANUAL
11 TROUBLESHOOTING
Probable Cause Remedy
Damaged blade(s). Replace blade(s).
Turning too aggressively. Cutting units don’t
overlap during turns or on side hills.
Turn less aggressively to allow cutting units to overlap.
Change mowing direction or pattern on side hills.
Tire mats down grass before it is cut.
Check/adjust tire inflation pressure. (Refer to Parts &
Maintenance Manual.)
Wet grass is matted down before it is cut. Cut when grass is dry.
11.2.5Streaks
NOTE: Arrow indicates direction of travel.
A streak is a line of uncut grass. This is usually caused
by a damaged blade.
To Next Page
Loading...
