Jacobsen PGM 22 Parts And Maintenance Manual

3 ADJUSTMENTS
GB-10
3.5 CUTTING HEIGHT _________________________________________________________
Note:
Make sure the bedknife is properly adjusted before
setting the cutting height. (Section 3.3).
1. Tip mower back on traction drum or tires. Do not
leave the mower tipped back for an extended length
of time or oil may migrate into the combustion cham-
ber.
2. Loosen nuts
(M)
on both sides just enough to allow
knob
(L)
to raise the front roller or Turf Groomer.
Raise both sides an equal amount.
3. Set gauge screw
(P)
to the desired cutting height
(O)
. Measure from the gauge bar
(N)
to the
underside of the screw head
(P)
then tighten wing
nut to lock the adjustment.
4. Place gauge bar between front roller and traction
roller, near the outer end of the rollers.
5. Slide screw head over bedknife
(Q)
and adjust knob
(L)
so roller just contacts the gauge bar. Tighten nut
(M)
.
6. Repeat Steps 4 and 5 on the opposite end of the
reel then tighten nuts
(M)
. Recheck and readjust the
cutting height if necessary.
Figure 3E
3.6 OPC LOCK-OUT___________________________________________________________
Adjust screw
(R)
so that the OPC bail
(T)
stops shortly
after OPC lock out lever
(S)
engages the OPC bail.
Figure 3F
L
M
N
O
P
Q
R
S
T

Jacobsen PGM 22 Specifications

General

Brand	Jacobsen
Model	PGM 22
Category	Lawn Mower
Language	English