EasyManuals Logo

Jacuzzi BALI User Manual

Jacuzzi BALI
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #39 background imageLoading...
Page #39 background image
39
Q The end of the scale removal cycle is signalled by the turning o of the LED found
above the button, and the display shows the temperature value of the enclosure area.
QYOU can stop the cycle by pressing the button ; wait about ve minutes before turn-
ing o the main switch, so that the steam generator is emptied and the solenoid valve is
drained.
Q If two buttons are pressed at the same time by mistake, the control panel may temporarily
lock. Wait for a few seconds for operation to be restored.
Q After use, switch o the shower unit by pressing the "on/o" button .
Then switch o the main switch.
The presence of malfunctions and / or situations that may require the intervention of a
Jacuzzi®Service Centre are shown on the display for approximately 10 minutes with alpha-
numeric abbreviations (by pressing the button
you can delete some messages from the
display; however, the error condition remains).
- First check that the shower unit is powered (main switch on, electric and hydraulic
system functioning, etc.)
- Then follow the indications given for each type of anomaly and try to switch the
shower enclosure o and on again. If the problem persists, contact a Jacuzzi® service
centre.
XE2 - activation of safety thermostat
- Contact a Jacuzzi® service centre.
XE3 - the time available for the water load in the steam generator has expired
- Check that the water supply is not closed or faulty;
- Contact a Jacuzzi® service centre.
XE4 / E5 - temperature probe (or relative circuit) faulty
- Contact a Jacuzzi® service centre.
XE6 - no Bluetooth® device or connection
- Associate a Bluetooth® device or verify that it is connected (refer to the respective chap-
ter);
- Check that the connection has not been interrupted (device too far away, momentary
signal drop, etc.).
XE7 - failure of the drainage solenoid valve (also see the section on “Special Maintenance”)
- The boiler may need to be inspected; contact a Jacuzzi® service centre.
General notes
Error messages
(only Bali hammam model)

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Jacuzzi BALI and is the answer not in the manual?

Jacuzzi BALI Specifications

General IconGeneral
ShapeRectangular
MaterialAcrylic
OverflowYes
Product TypeBathtub
Color OptionsWhite

Related product manuals