Jacuzzi city spa - Technical Features; User Safety; Arrangement for Installation

1313
It is the responsibility of the installer/owner to ascertain
compliance with specic local regulations prior to installa-
tion. Jacuzzi Europe S.p.A. gives no guarantee in this respect
and declines all responsibility regarding the compliance of
the installation performed.
Technical Features
City™ Spa ( 1;  2) comes with a 2 Hp pump and a recircula-
tion pump.
City™ Spa is equipped with a cartridge lter that ensures excel-
lent water ltering (ltering surface: 4.6 m
2
).
City™ Spa is also available with perimeter panels of the follow-
ing types:
- wood panels (--> Sasha)
(only for interior installations)
- wood panels (with teak nishing)
(for both indoor and outdoor installation).
- composite wood panels
(for both indoor and outdoor installation).
- ( 2) customised panels, on which coatings with thickness
of a couple of millimetres may be applied. If you want to apply
thicker coverings (mosaic, tiles, etc.), you can partially mill the
unnished panel.
Maximum absorption of the system
• VERSION WITH HEATER 2 KW
Power supply (x) Total consumption
· electric heater + hydromassage + ltering
Audio System
(optional)
Voltage
220-240 ~ 50/60 17,5 (k) 4,0 (j) 0,25 (j)
Hertz Ampere kW kW
• VERSION WITH HEATER 1,5 KW
Power supply (x)
Total consumption
· electric heater + ltering
·
only hydromassage
Audio System
(optional)
Voltage
220-240 ~ 50/60 8 (k) 1,8 (j) 0,25 (j)
Hertz Ampere kW kW
(k): at 230 V - (j): absorbed power
(x): see “Electrical preparations”
The electrical system that powers the spa must absolutely be
sized for maximum consumption (as shown in the table).
Weights
Net weight average ll water volume
MAX
Total max. weight
kg litres litres kg
~ 220 ~ 470 ~ 570 ~ 790
support area concentrated load
on support area
m
2
kg/m
2
~ 2,25 ~ 350
User safety
Q If installed by qualied personnel in compliance with the in-
structions in the enclosed installation manual, the system does
not present any risks for the user. However, safety is also contin-
gent upon appropriate use, according to the provisions in the
respective manual, while the user must delegate the operations
described in the installation manual to qualied personnel.
Q It is important to make sure that personnel tasked to install
or manage the system are qualied as per legal requirements in
eect in the country where installation is carried out.
QFor special maintenance operations and/or repairs, you should
always contact authorised Jacuzzi® service centres and use only
original spare parts.
Arrangement for installation
Q City™ Spa requires the following plumbing connections (ar-
ranged as in  1 and 3):
- B: spa drainage.
- C: connection of overow; to be made in the eld, after drilling
a hold in the bottom of the support base, depending on the type
of installation.
The customer must make provisions for a ground drainage point
of suitable dimensions and that can be inspected for any clean-
ing that may be required.

ATTENTION: Before preparing the ground drainage
point, consult the local authority for the regulations
that control the drainage of chemically treated water.

If installation is made indoors, it is advisable to provide a
drain system under the support area of the spa which is con-
nected to the main drain, connecting the main drain also to
the tting present on the base (3, det.B3).
Considering the large amount of water in the spa, this pre-
caution is advisable should there be accidental water leak-
age (also see
8, det.5).