Jacuzzi Delos Pro - Water Filtering; Setting Filtering Cycles; Istant Clear; Water Heating

26
Water ltering
F
iltration, which is achieved through the combined action of the
pump and the cartridge lters, is extremely important in order
to keep the water clean and transparent and eliminate suspended
particles.
N.B.: some models are equipped with a UV light (Clearray™), which
helps disinfect and purify the water. When the ltering cycle is start-
ed, the generator starts automatically, and shuts o at the end of
the cycle.
Even if a ltration cycle is not running, when the hydromassage,
blower or even only the spotlight is activated, the ltering pump
turns on automatically (because it is presumed that someone is
in the tub and therefore there are suspended particles that could
worsen water quality). The ltering pump will continue to run for 10
minutes after the functions are turned o.
Setting the ltering cycles
To set the ltering cycle:
XPress the “Filter” key for about 5 seconds. The display
shows the message Fdx, where “x” indicates the duration in hours.
XUse the “Up”
and/or “Down” keys to insert the desired
duration. This may be from a minimum of 0 to a maximum of 12
hours, which corresponds to constant ltering, since the cycle runs
every 12 hours in any case.
XPress the “Filter” key again to conrm the selected value.
You will then go to the start time (Fs).
XFirst set the hour and conrm with the “Filter” key. Then set
the minutes, and press the “Filter” key again to save the set va-
lues and exit programming.
When the function is on, the display will shown the respective
symbol.
NOTE: if there is a power outage, the set values will be maintained.
“Instant Clear”
This special type of ltering is recommended in special situations,
such as before or after a party with friends, or to facilitate dissolu-
tion of substances used for water disinfection.
XTo activate this function, press and hold down the “Instant
Clear”
key for 5 seconds. The display will show the message
boo.
XThe function lasts 45 minutes (this value cannot be changed),
but can be stopped sooner by pressing the same key. The ltra-
tion pump and the hydromassage pumps are activated accord-
ing to a particular cycle.
For details on ltering, refer to the product’s installation
manual.
Water heating
T
he water in the tub is heated by an electric heater (or heat ex-
changer) located in the tub compartment; the temperature is
adjusted based on specific parameters, which are set using the
control panel.
XPress the “Up” or “Down” key. The display will show the
current memorized temperature and the respective symbol ap-
pears.