Jacuzzi Delos Pro - Routine Maintenance; Maintenance of Cartridge Filters; Maintenance of Thermal Cover

29
ROUTINE MAINTENANCE
XKeep the spa covered at all times when not in use. In this way,
along with keeping the water from getting dirty, you will also
avoid heat loss and evaporation.
XPeriodically clean the hydromassage and suction nozzles.
CAUTION

After cleaning, immediately put the grilles of the aspira-
tion nozzles back in place. These safety devices must co-
ver the suction intake in order to reduce the risk of hair
or other body parts getting caught. The intakes must be
cleaned with the bath empty.
Remember to ret all the parts before re-lling the spa.
The suction intake grilles must be checked at least once
a week.
XRegularly clean the headrests using a cloth, soap and water.
You are advised to use protective products to increase water re-
sistance and maintain their shiny appearance.
QMaintenance of cartridge lters
The lters must be periodically cleaned according to the amount
of use of the spa and replaced when necessary
The cartridges are available from Jacuzzi® authorised dealers
and Service Centres.
XCheck the skimmer at least once a week to remove any sedi-
ment such as leaves, hair, etc.
XWith normal use of the spa, it is advisable to clean the lters
at least once a week. If necessary, the lters should be cleaned,
because clogged lters cannot keep the water clean. They also
compromise proper operation of the system.
XTo clean the lters, remove the skimmer cover (C), unscrew
the lter baskets and take them out.
1
2
3
4
XSeparate the lter folds and clean with a jet of pressurised water.
If the lter is clogged, it is advisable to use specic products for
the removal of encrustation and grease, available from authori-
zed Jacuzzi® dealers and service centres.
XRet, repeating the operations in reverse order.
CAUTION

After cleaning the lters, do not re-start the spa until
you have re-assembled all components.
QMaintenance of thermal cover
Fabric
XRemove the cover from the support frame and lay it on a
straight surface.
XDampen the fabric with clean water. For a plastic cover, you
can proceed directly with cleaning.
XEvenly spread a diluted solution of neutral soap on the sur-
face.
XLet the solution stand for 2-3 minutes, depending on the
degree of dirtiness.